Proper adjustment of slack adjusters is essential to the functionality of trailer brakes. Slack adjusters compensate for normal wear of break linings. The slack adjuster is an arm attached to a push rod on the brake assembly. Performing a slack adjustment means simply adjusting the push rod in the air chamber to within a predetermined tolerance, thereby maintaining optimal brake performance.
Instructions
How to Adjust Slack Adjusters on Trailer Brakes
- 1
Before beginning your adjustment, it is important to block the tires to prevent the trailer from moving. The best way to avoid movement is to raise the vehicle on jack stands during the adjustment. Have the brake system at full pressure, lower the emergency brake, and push in the air valve, thereby releasing the brakes. Listen for any air leaks, as they can decrease your braking ability.
Using a piece of chalk, mark the push rod where it leaves the air chamber.
2Using a screwdriver for leverage, pull the push rod out of the air chamber, and measure from the chalk line to the air chamber. That shows you the "stroke range"; anything more than three-quarters of an inch would mean the brakes need an adjustment.
3Locate the manual slack adjuster bolt. It connects the s-cam to the air chamber on the axle housing with the push rod. Using the appropriate sized wrench, turn the slack adjuster. Watch the s-cam to see the direction it is moving to ensure you are adjusting it correctly. You can tell you are adjusting it the wrong way if the push rod is pulling out of the air chamber.
Continue tightening until you feel resistance, which means you have drawn the brake linings to the drum.
4Reverse the slack adjuster one-quarter to one-half of a turn to put a little distance between the drum and the linings.
5Pressurize the system and apply the brakes using normal pressure. You should have no more than one-tenth of an inch between the brake linings and the drum, and there should be no more that 2 inches of travel in the push rod stroke.
0 comments:
Post a Comment